1-800-843-6036

Click Here to Email Us

Supported Browsers IE, SAFARI, CHROME

SuperDuct™ Duct Smoke Detector

SUPERDUCT™

DUCT SMOKE DETECTOR

4-Wire, Photoelectric Type

SD SERIES

The SuperDuct's advanced circuit board-mounted photoelectric sensor is an integral part of the detector assembly and features environmental compensation that does away with sensitivity drift once and for all, ensuring unparalleled stability and reliability even under harsh environmental conditions.  With its innovative remote test station, SuperDuct detectors can be tested for dirt contamination remotely, eliminating the need to physically access the detector with a sensitivity tester.  This feature saves countless hours of fumbling with ladders and climbing into awkward spaces.

Snap-in RJ45 connectors reduces time spent on controller/detector interconnection to just a few seconds, while sampling tube spacing, and even field wiring connections, match standard configurations, making SuperDuct a drop-in-alternative to bulky, outdated products on the Market today.  With a wide range of available accessories, SuperDuct provides a simple-to-install, easy-to-maintain, and highly-reliable solution for duct smoke detection needs.

SPECIFICATIONS

• -20f to 158F operating range with 100 ft/min to 4,000 ft/min air velocity

• Operating humidity:  10-93% R.H. non-condensing

• 3%/ft + /-1.0% sensitivity

• 20-31V DC, 24V AC, 120V AC, 220/230V AC models

• Standby current:  25 mA RMS @ 120VAC;     15mA RMS @ 220VAC

• Alarm Current:  35 mA RMS@120VAC; 25mA@220VAC

FEATURES

• Less than 2" deep for easy installation & applications where space is tight

• PCB mounted photoelectric sensor with on-board intelligence

• Environmental compensation with patented differential sensing

• Standard RJ45 interconnection

• Status LEDs remain visible even after installation

• Cover tamper reed switch

• Sampling tubes install from room-side or air-side

• Magnet-activated test/dirty switch

RJ45 WIRING HARNESSES

These 8-conductor cables are used to interconnect detectors with controllers.  Harnesses are available in 5 Ft., 10ft., and 15 ft. lengths.  They include RJ45 connectors with rubber glands to provide a watertight seal at each end.

AIR SAMPLING TUBES

Rigid metal sampling tubes are available in lengths of 8", 23", 42", 78", and 120".  They are installed without the need to open the detector.

AIR VELOCITY TEST KIT

With this kit, and a suitable manometer, testing can be carried out with the duct detector,  fully installed and wired.

TEST MAGNET

Used to activate test routine from either a SD-TRM4 Remote Test/Reset Station, or the detector.

REMOTE INSTALLATION ADAPTER

The remote adapter allows the air sample tube to be installed remotely from the detector.  This adapter is designed for connection to flexible, high-temperature, reinforced hose with suitable fittings (provided by others) at each end.  Adapters come with collar, gaskets, and mounting screws.

REMOTE TEST/RESET STATION

The Remote Test/Reset Station provides alarm test or dirty test capability from a remote location.  It includes a one-gang plate, momentary SPST switch, red alarm LED, yellow trouble LED, green power LED, and terminal block.  Magnetically-operated or key-operated models are available.  

Current Load @ 24 Vdc:                                                   standby=5mA                                                                   alarm = 15mA max.                                                         

Controllers and Detectors

Accessories

Prices are subject to change without notice. Inventory is subject to prior sale. Product design, specifications & construction are subject to change without notice. Pictures are for general representational purposes and may not represent actual product.

Not Responsible for errors in print, verify all data with us or manufacturer. Terms & Conditions of sale apply, for a copy contact us.

Products may be discontinued without notice.